Meets with two standards: half rope and twin rope
All of our ropes are designed and tested in Chamonix, in the Mont Blanc valley.
They are made in northern France by our manufacturing partner, Cousin, expert rope makers with 170 years of experience.
UIAA Dry treatment
This rope has the UIAA Water Repellent label
A brief summary of test:
- A rope sample is subjected to light abrasion over its entire surface, the equivalent to a few days’ use.
- It is soaked for 15 minutes.
- the amount of absorbed water must not be greater than 5% of the sample’s weight.
The SIMOND DRY ropes easily meet UIAA requirements
The rope's mechanical features are last longer in cold and wet conditions.
Ultrasound seal
Deterioration of rope ends is no longer an issue thanks to this new ultrasound fusion process.
Middle marking
To improve your safety, this rope features a black mark which indicates the middle of the rope.
Weight
37 g/m
PLEASE NOTE: Weight measurements made according to the EN 892 standard.
For example, for a single rope, the rope must be exposed to 10 kg of tension for 1 minute in very precise temperature and moisture conditions.
This gives you the real weight of the rope, which is often superior to the weight given by the standard.
The weight measurement according to the standard is used to compare two ropes to each other.
Technical features
Number of falls: 5/12
Impact force: 5.7 / 9.1 KN
Dynamic elongation: 30.4% / 27%
Static elongation: 11.4% / 6.6%
Sliding of the sheath: 0
Stds/Certif.
EN 892:+A2: 2021.
Checking your rope
It is important to check your rope regularly. To do so, run the rope through your hands and inspect it metre by metre along its entire length. This will allow you to spot any nicks, cuts, abrasion or weak points. If you notice any anomalies or irregularities, if the core is visible in certain places, if the rope is deformed or has exceeded its fall rating, it must be changed. Take safety seriously!
