Lightweight inflatable floor
Ideal for regular use, Plastimo's FUN inflatable tender features a lightweight and compact inflatable floor. In addition, its V-shaped hull gives it very good handling at sea. Flaps extend the floor at the back of the tender to assist the craft's acceleration and lift off.
Structure of the FUN Pi320VB inflatable tender
The Pi320VB inflatable tender has 3+2 compartments. The tubes are 43 centimetres in diameter and the inflation valves are fully recessed in the tubes; they are protected and easy to access.
Maximum load on board and maximum engine size
The Fun Pi320VB tender can carry four adults up to a maximum load of 736 kg. The tender can accommodate an engine with a maximum power of 11.03 kW or 15 HP.
Dimensions and weight
For model Pi320VB:
- Overall dimensions: 321 x 154 x 75 cm
- Folded dimensions of the tender: 112 x 60 x 33 cm
- Weight: 31 kg
FUN Pi320VB inflatable tender extras
The Plastimo FUN Pi320VB inflatable tender includes an aluminium seat, two towing rings and three carry handles (one at the front and two at the rear). In addition, the tender comes with a selection of equipment: straps for fuel tank, a carry bag, a repair kit, a pump and two oars.
Tender inflation instructions
Inflate the boat using the pump supplied with the tender. The maximum pressure is 0.25 bar for the boat and 0.35 bar for the keel, 0.60 bar for the inflatable floor and 0.80 bar for the fixed floor. Depending on climate and operating conditions, the pressure should be monitored during boat use to maintain a suitable inflation level. During inflation, maintain a balance of air between air chambers. This will prevent damage to the walls.
Recommendations for using the tender
Every person on board must wear a life jacket. The oars, as well as the repair kit, must always be on board in case of emergency. All loads on board must be distributed evenly in order to ensure the trim of the boat is suitable once in the water.
How to maintain your inflatable tender
Rinse the tender, if possible after each use. At the end of the season, wash it with soapy water or with washing-up liquid. Rinse and leave it to dry before folding it up and storing it in a dry place.
NOTE: DO NOT use a vinyl preserving agent. The chemicals can dry out the material.
Wheel kit available as an optional extra
If required, the manufacturer Plastimo has developed tender wheels suitable for FUN boat tender models. They are simple to set up and make launching easier.
Plastimo, a benchmark player in the boat tender market
For more than 25 years, Plastimo has been designing tenders for the needs of all boaters and rental professionals. Building on customer feedback, Plastimo continues to develop the range by incorporating the latest technologies: for even better safety and ease of handling.
