- Membraned 3-layer fabric
- A strong rain corresponds to a flow of 450L/m2/h - (= rainfall of 450 mm/h)
- The rainfall simulator reproduces these conditions for 3*8 hours.
- Component resistant to water pressure of 10,000 mm after ageing, = 10,000 Schmerber - average pressure of water during a storm
- Water repellent components (water runs off the fabric).
- 100% taped seams.
- Central opening features a flap with a drainage channel for optimal waterproofing

Two-way adjustable hood with semi-rigid visor and drainage channel.
Synthetic rubber sleeve cuffs adjustable by rip-tab strips.
Adjustable synthetic rubber neck.
Adjustable neoprene waistband for a perfect fit with the overalls

RET <20: breathable.
To find out whether a fabric is breathable, we measure its evaporative resistance, or RET, (test based on the ISO 11092 standard). It is its ability to allow the water vapour produced by the body during exercise to escape.

21 cm fleece collar (back)
Weight: 1110 g in size L
Fleece hand pockets
Compartmented front pocket for a knife or VHF

2 shoulder patches
2 hood patches
intensifying sources of low light

Injected plastic central zip resistant to salt oxidation.Coating to prevent oxidation, which impairs membranes

Close all zips and flaps and remove any parts of the garment that cannot be washed. Also remember to loosen the straps and elastic parts and empty the pockets.
Then turn the garment inside out to wash it.

You can wash your jacket on a synthetic cycle at 30° or 40°C with your usual detergent. Do not use fabric conditi1r, which could damage the existing performance of the garment, or bleach.

Also take care not to bend your jacket too much when you place it in the washing machine and do not overload your machine.
Very important: select a thorough rinse or double rinse to completely remove all detergent residue.

Drying is a crucial phase in reactivating the water repellent treatment.
We recommend that you lay your anorak flat on a clothes rack and leave it out to dry in the open. Caution: never dry your anorak directly on a radiator.Then place it in the tumble dryer on a short synthetics cycle, i.e. 10 to 15 minutes, before turning it back the right way round. Caution: do not over-dry the garment.

If, despite this procedure of washing and thorough rinsing followed by gentle drying in a tumble dryer, the drops of water no longer run off the surface of your jacket, we recommend that you "re-waterproof" it using a spray sold in our stores.